Cluster I/O Protocols (CIP) Configuration and Management Manual (H06.16+, J06.05+)

eth4 UP UP
IPv4: 172.17.190.33
IPv6: 3ffe:1200:190:2:21f:29ff:fe0d:ac1f
IPv6: 3ffe:1200:190:1:21f:29ff:fe0d:ac1f
IPv6: fe80::21f:29ff:fe0d:ac1f
Data Provider LOOP Interface Status & IP Addresses:
Flg Name Status LkP Master / IP Family & Address
lo UP --
IPv4: 127.0.3.2
IPv4: 127.0.0.1
IPv6: ::1
Interface Failover Configuration and Status:
Flg Name Failover/(Assoc) Fovr Current Provider
C100271.eth5 C100263.eth5 Home C100271.eth5 CSAM
C100271.bond1 -- C100271.bond1 CSAM
(T) C100271.TUN0 (C100271.eth1) Home C100271.TUN0 CSAM
C100271.eth1 C100263.eth1 Home C100271.eth1 CSAM
C100271.eth4 -- C100271.eth4 CSAM2
NOTE: The Fiber attribute might not be supported on your system. For more information, see the
planning guide for your system.
NOTE: CLIM Maintenance Interface Status & IP Addresses, Maintenance Provider Interface Status
& IP Addresses, and Data Interface Status & IP Addresses are usually available only if the CLIM is
in the STARTED state.
Mode
Shows the operation mode of the CLIM. An IP CLIM (Mode is IP) provides access to TCP/IP
networking. A STORAGE CLIM (Mode is STORAGE) provides access to disks and other storage
devices. An OPEN CLIM (Mode is OPEN) provides access to hosting application code other
than the standard HP CLIM code and can be used for telecommunication or financial
applications. CLIM can provide both access to TCP/IP networking and access to disks and
other storage devices.
MultiProv
Indicates whether the specified IP or OPEN MODE CLIM supports association with multiple
IPDATA providers simultaneously.
CLIM HW Connection Status
Indicates overall hardware connectivity between a CLIM and this NonStop system at the
configured locations and can have any of the values:
CLIM is connected at all configured locations and is usable.Connected
CLIM is connected at some but not all configured locations and is usable.Partially Connected
CLIM is not connected at any of the configured locations (not usable).Not Connected
Two or more CLIMs are connected to the configured locations (not usable).Conflict
A connection problem exists at one or more configured locations (not usable).Connection Problem
State
Shows the CLIM object state, either STOPPED, STARTING, or STARTED. If the object is STOPPED,
the subsequent fields are omitted. If the object is not STARTED, the CLIM restart time, hostname,
versions, and interface status fields are omitted.
260 SCF Reference for CIP