Cluster I/O Protocols (CIP) Configuration and Management Manual (H06.16+, J06.05+)

Fabric Status
Displays the CIPMON status, connections to the CLIM, and availability of the X and Y ServerNet
fabrics for each running processor in the system. The Mgmt column shows the management
connection to CLIMAGT, and the Data column shows the data path connections to the CIPSSRV
processes. The possible values are:
CIPMON is down.MON-DOWN
CIPMON is up, but no connection is established.--
Connection is established; only the X fabric is available.X-
Connection is established; only the Y fabric is available.-Y
Connection is established; X and Y fabrics are available.XY
The number suffix (for example, -1) indicates the particular set of ServerNet fabrics being used
for the connection with the CLIM. For example XY-1 indicates that a connection is established
on both fabrics using SvNet ID 1 (that is, ServerNet ID of the first set of ServerNet connections).
CLIM Maintenance Interface Status & IP Addresses
Shows the dedicated service LAN interface (eth0) on the CLIM, giving the interface status (UP
or DOWN), link pulse status, and IP address. If multiple IP addresses are associated with the
maintenance interface, they are shown on separate lines.
Maintenance Provider Interface Status & IP Addresses
Shows the maintenance provider interface (eth0:0) on the CLIM configured to support
Maintenance Provider, showing:
Name of maintenance provider interface on the CLIM (eth0:0)Interface name
UP, DOWN or DNOP (down due to operator command)Interface status
UP, DOWN, or — if no link pulse statusLink pulse status
IP address family and actual IP address for the interfaceIP address(es)
If multiple IP addresses are associated with the maintenance provider interface, they are shown
on separate lines.
This attribute is applicable only when there is a maintenance provider interface configured on
the CLIM and if the CLIM has IP MODE. Link pulse status of the maintenance provider interface
is identical to link pulse status of CLIM dedicated service LAN interface.
Data Provider prov-name Interface Status & IP Addresses
Shows the CLIM’s data interfaces on the CLIM for a particular provider, including:
Indicates a special condition of the interface or IP address:Flag
• (V) for IP address created to support failover from other CLIM
• (F) for interface that is currently active on a different CLIM)
• (T) for manually configured IPv6-over-IPv4 tunnel interface
• (X) indicates an interface whose failover configuration is invalid
Is the name of the interface on the CLIMInterface name
Is UP, RDY, DNOP, or DOWN.Interface status
• UP indicates the interface resources are active and usable
• RDY indicates the interface is usable but resources are not active
262 SCF Reference for CIP