Cluster I/O Protocols (CIP) Configuration and Management Manual (H06.16+, J06.05+)

Indicates the current location of the interface (home interface or failover interface). If there
is no failover (HOME or __), the location is the same as the interface name. If there is failover,
then this field is identical to the failover interface at the time of the failover.
Current location
Indicates the name of the associated IPDATA provider.Provider
NOTE: Interface failover status is only applicable when CLIM has IP or OPEN MODE.
NOTE: In special cases, current can be something other than the home interface or the
current failover interface. In such a case, current is the previous failover interface (which
was correct at the time the interface failed over), but the failover configuration for that interface
has changed to use a different failover interface.
Example 70: STATUS CLIM, Starting displays detailed status information on a CLIM in STARTING
state:
Example 70 STATUS CLIM, Starting
> STATUS CLIM $ZZCIP.N1002541, DETAIL
CIP Detailed Status CLIM \MYSYS.$ZZCIP.N1002541
Mode...................... IP
MultiProv................. ON
CLIM HW Connection Status. Not Connected
State..................... STARTING
ConnPts................... 2
X1 Location............... Group 100 , Module 2 , Slot 5 , Port 4 , Fiber 1
Y1 Location............... Group 100 , Module 3 , Slot 7 , Port 4 , Fiber 1
X1 Location............... Group 100 , Module 2 , Slot 5 , Port 4 , Fiber 2
Y1 Location............... Group 100 , Module 3 , Slot 7 , Port 4 , Fiber 2
X1 Connection Status...... Not Connected
Y1 Connection Status...... Not Connected
X2 Connection Status...... Not Connected
Y2 Connection Status...... Not Connected
Trace Status.............. OFF
Last Known Problem........ CLIM Hardware Not Connected
Last Known MultiProv IPDATA Provider Associations:
ZTC0
ZSAM1
Last Known Problem
Shows last known reason for the CLIM staying in STARTING state. This entry applies to
STARTING state, only, and is not shown for CLIMs in STOPPED or STARTED state.
Last Known MultiProv IPDATA Provider Associations
Lists the IPDATA providers that are associated with this CLIM based on the last known
configuration information for that CLIM. This entry applies only when the CLIM has IP or OPEN
MODE with MULTIPROV ON in STARTING or STOPPED state. This entry is not shown for CLIMs
with STORAGE MODE, CLIMs with MULTIPROV OFF or CLIMs in STARTED state. If there are
no known IPDATA providers associated with a CLIM with MULTIPROV ON, no names are
listed.
Example 71: STATUS CLIM, Detailed, Storage CLIM displays detailed status information for CLIM
S1002553:
Example 71 STATUS CLIM, Detailed, Storage CLIM
> STATUS CLIM $ZZCIP.S1002553, DETAIL
CIP Detailed Status CLIM \MYSYS.$ZZCIP.S1002553
264 SCF Reference for CIP