Cluster I/O Protocols (CIP) Configuration and Management Manual (H06.16+, J06.05+)

Example 93 VERSION MON Detailed
> VERSION MON $ZZCIP.ZCM03, DETAIL
Version PROCESS \MYSYS.$ZZCIP.ZCM03
CIPMonitor - T0694H01_01AUG2008_AAB_MON_Q41
GUARDIAN - T9050 - {T06)
SCF KERNEL - T9082H01 - (04DEC06) )15NOV06)
CIP PM - T0695H01 - (05AUG2008) (H01 SCF AAB)
VERSION PROCESS
The VERSION PROCESS command displays the version number of the CIPMAN process.
VERSION PROCESS Command Syntax
VERSION PROCESS $ZZCIP [,DETAIL]
Example 94 displays the version of CIPMAN.
Example 94 VERSION PROCESS
> VERSION PROCESS $ZZCIP
T0690H01_01AUG08_AAB_MAN_Q38
CIPSAM SCF Commands
The SCF commands for CIPSAM support the PROCESS and SUBNET objects and require the name
of a CIPSAM process running on this system. The SUBNET object refers to a home CLIM interface
as seen from the NonStop host system. SUBNET object names are generated by CIPSAM and
consist of “#SN” followed by a four-digit number. They are assigned to interfaces when the interfaces
are first reported and do not change as long as the CIP subsystem continues running. The INFO
SUBNET command displays the CLIM and interface name referenced by a SUBNET object.
Table 25 lists the SCF commands and object types supported by the CIPSAM process. The page
number of the command description follows the command name.
ABORT Command, CIPSAM
The only supported ABORT command for CIPSAM is ABORT PROCESS.
ABORT PROCESS
The ABORT PROCESS command for CIPSAM stops and deletes the CIPSAM process immediately,
without regard for open sockets. Open sockets using the CIPSAM process are not affected, but no
new sockets can be created.
ABORT PROCESS Command Syntax
ABORT PROCESS $cipsam-name
cipsam-name
Is the name of the CIPSAM process to abort.
Example 95 displays the command to abort the CIPSAM process named $ZTC1.
Example 95 ABORT PROCESS
> ABORT PROCESS $ZTC1
INFO Commands, CIPSAM
The INFO PROCESS and INFO SUBNET commands are supported for the CIPSAM process.
CIPSAM SCF Commands 281