Cluster I/O Protocols (CIP) Configuration and Management Manual (H06.16+, J06.05+)

climstatus(1)
NAME
climstatus -- displays CLIM specific status information
SYNOPSIS
CLIMCMD {clim-name|ip-address} climstatus [-o option]
climstatus Description
climstatus is a program that provides active status information about active objects on specific
CLIMs: (See climconfig(1) for information on obtaining permanent configuration information.)
- ServerNet
- EtherNet, Local Area Network (LAN)
- Kernel IP Routing Table
- Secondary Storage Devices, Hard Disk Drives (HDD)
- IP Security policies and associations
- Interface Failover configuration
- SNMP Configuration information
- climprep configuration information
- iptables and ip6tables configuration
climstatus, when invoked, provides status information of all the above-mentioned components by
default. However, a user can view status information pertaining to a particular component by
providing a -o option to the climstatus command, followed by a character that represents the desired
component. The set of characters representing each component is listed under Parameters.
PARAMETERS
This section lists the options that can be used after the -o option.
c
Displays climprep information.
f
Displays interface failover information.
h
Displays the information pertaining to Filesystem Disk space usage on the CLIM. Displays
information specific to the Filesystem disk space and usage status, such as name, type, size,
used and available amount of space, percentage of used space, and the mount point.
i
Displays the information pertaining to the IPSec, such as security policies and associations.
l
Displays the status information pertaining to Local Area Network (EtherNet) only. Displays
information specific to the Network such as the Interface name, type, status, link status, and IP
addresses(both IPv4 and IPv6). The LAN information is categorized into three separate classes:
Maintenance, Maintenance Provider and Data. The interface "eth0" is the onboard interface
that has been reserved as the Maintenance interface and is used for clim internal housekeeping
activities. The other interfaces are open for normal Data usage.
m
Displays CLIM SNMP information.
294