Cluster I/O Protocols (CIP) Configuration and Management Manual (H06.16+, J06.05+)

ifstart(1)

NAME

ifstart -- start an interface

SYNOPSIS

CLIMCMD {clim-name|ip-address} ifstart interface

ifstart Description

ifstart allows you to activate an interface if you have stopped the interface using the ifstop command.

For all network interfaces (ethernet, ip-over-infiniband, bonding and tunnel interfaces), this command

activates the specified interface.

PARAMETERS

interface

Specifies the name of the network interface that is to be started and made available to the

NonStop host. The interface name can be specified as a physical or bonded interface name,

for example, eth1 or bond0 or ib0, or a tunnel interface (for example, MYTUN).

ERROR MESSAGES

The interface interface-name is not configured.

This command is not supported for this interface.

climagt process is not executing.

Interface is already in started state.

CONSIDERATIONS

None.

EXAMPLES

> CLIMCMD N1002581 ifstart eth3