Cluster I/O Protocols (CIP) Configuration and Management Manual (H06.16+, J06.05+)

climconfig.failover(1)
NAME
climconfig.failover -- configure failover
SYNOPSIS
CLIMCMD {clim-name|ip-address} climconfig failover -add src-interface
-dest dest-clim-name.dest-interface
CLIMCMD {clim-name|ip-address} climconfig failover -delete
{src-interface|all} [-force]
CLIMCMD {clim-name|ip-address} climconfig failover -info
clim-name -interface {interface-name|all}[-obeyform]
climconfig.failover Description
This command allows you to configure the failover behavior between CLIMs. You can configure
both physical and bonding interfaces to failover to an interface on a different CLIM.
failover -add
adds a failover configuration to the failover.conf file. The command must be run for the
CLIM that contains the src-interface for which the failover configuration is to be added.
failover -delete
deletes the failover configuration for the specified interface. The command must be run for the
CLIM that contains the src-interface with the failover configuration that is to be deleted.
failover -info
displays the failover configuration of the specified interface. This command can be run for any
CLIM.
PARAMETERS
src-interface
Specifies the native interface name. It can be a physical (Ethernet or InfiniBand) or bonding
interface.
dest-clim-name
Specifies the destination CLIM.
dest-interface
Specifies the destination interface. The specified interface can be a physical interface (Ethernet
or InfiniBand) or a bonding interface.
-all
Deletes all of the failover configurations for the native CLIM.
clim-name
Specifies the CLIM containing the interface whose failover configuration is to be displayed.
-clim
Is the interface containing the failover configuration to display. If you specify interface-name
the output is only one line.
interface-name
Specifies the interface for the failover configuration. For the -info command, the display format
is: clim-name.interface-name.failover clim name.failover-interface
all
Specifies all failover configurations for the CLIM. The display format is:
clim-name.interface-name failover-clim-name.failover-interface-name
310