Cluster I/O Protocols (CIP) Configuration and Management Manual (H06.16+, J06.05+)

-prov
Specifies a provider name. This option is mandatory for CLIMs that have MULTIPROV set to
ON and cannot be used if MULTIPROV is set to OFF. Each provider has its own interface
configuration. The provider name is case-insensitive and always converted to UPPER case.
-netmask netmask
Specifies an IPv4 network address in dotted quad form.
all
Displays information for all interfaces.
-obeyform
This option displays the user-configured resources of an interface in add command format.
-mtu
Sets frame size for an interface. If the option is not specified, the default frame size is 1500.
For physical and bonding interface allowable values are 1280 to 9000.
For tunnel interfaces allowable values are 1280 to 65508.
If the mtu option is set for bonding interface, it will also be applied to a slave interface.
Setting mtu option separately for a slave interface is not allowed.
You cannot specify both the jumbo and mtu options.
mtu cannot be specified for eth0, eth0:0, and InfiniBand interfaces.
Specifying mtu overrides previous values set for jumbo.
-jumbo on
Changes jumbo frames for an interface other than eth0 or eth0:0. If jumbo is set (on), the frame
size is 9000 bytes. If jumbo is reset (off), the frame size is1500 bytes. If the option is not
specified, the default frame size is 1500 bytes.
The jumbo option has a limited set of allowable values (1500 - OFF and 9000 - ON) for frame
size, whereas the mtu option supports a range of values. The mtu option is the recommended
method for setting the MTU size.
The climconfig tool reports an error if the NIC does not support a frame size of 9000 bytes.
If the jumbo option is set for a bonding interface, it will also be applied to a slave interface.
Setting the jumbo option separately for a slave interface is not allowed.
If the bonding interface is UP, the jumbo option is set and a slave interface is added that does
not support frames of 9000 bytes, Climconfig reports an error while adding the slave interface.
You cannot specify both the jumbo and mtu options.
A jumbo frame cannot be set for eth0 and eth0:0.
Specifying jumbo overrides previous values set for mtu.
-jumbo off
Disables jumbo frames for an interface. The frame size is set to 1500 bytes. If this parameter
is not specified, the jumbo option is reset and the frame size set to 1500 bytes.
-force
Causes the command to modify the interface without prompting for confirmation.
-autonegotiation on
Enables autonegotiation.
-autonegotiation off
Disables autonegotiation. -linespeed and -duplex options must be specified.
-linespeed 10
Sets the linespeed to 10MB/sec.
316