Cluster I/O Protocols (CIP) Configuration and Management Manual (H06.16+, J06.05+)

-linespeed 100
Sets the linespeed to 100MB/sec.
-linespeed 1000
Sets the linespeed to 1000MB/sec. This option can be set only if -autonegotiation is set
to on.
-duplex half
Sets the duplex mode to half.
-duplex full
Sets the duplex mode to full.
-macaddr
Specifies the MAC address to be assigned to the specified interface. If default is specified,
the original hardware MAC address is assigned.
NOTE: When the interface is deleted from the configuration, either as a slave interface or
an independent interface, the configured software MAC address is not retained with the
interface.
ERROR MESSAGES
For interface -add:
The interface interface-name is already configured as an independent interface.
Interface interface-name is slave interface for a bonding interface. It cannot be configured
as an independent interface.
Interface interface-name does not exist in the kernel.
The -jumbo option is not supported for eth0/eth0:0.
The -mtu option is not supported for eth0/eth0:0 or for ib0/ib1.
Only one of -jumbo or -mtu options can be specified.
A value within the range 1280 to 9000 must be specified for -mtu option.
The –prov option is not supported for CLIM with SCF MULTIPROV option set to OFF.
The –prov option must be specified for CLIM with SCF MULTIPROV option set to ON.
The –prov option is not supported for eth0 and eth0:0.
The specified provider name is invalid; it must not be more than seven characters and must be
alpha-numeric characters with the first character being alphabetic.
For interface -delete:
This command is not supported for the interface eth0.
This command is not supported for the interface lo.
The interface interface-name is not configured.
The interface interface-name has a tunnel interface tunnel-interface-name associated
with it.
The interface interface-name is UP, cannot execute this command.
Cannot execute this command for the interface eth0:0, with eth0:0 in use.
For interface -modify:
This command is not supported for the interface lo.
The -jumbo option is not supported for eth0/eth0:0 or ib0/ib1.
The -mtu option is not supported for eth0/eth0:0.
Only one of -jumbo or -mtu options can be specified.
A value within the range 1280 to 9000 must be specified for -mtu option.
317