Cluster I/O Protocols (CIP) Configuration and Management Manual (H06.16+, J06.05+)

The IPv6 family cannot be specified for the eth0.
-ipaddress option for the command - "climconfig interface -modify", is supported only for eth0.
The interface interface-name is not configured.
Cannot execute this command for the interface eth0 when the CLIM is in STARTED state.
The tunnel interface and its parent interface have different jumbo settings.
Internal Error in updating SLNP rules, error-code.
The specified MAC address is not a software MAC address.The software MAC address of the
slaves slave-interface-1 and slave-interface-2 of bonding interface
bonding-interface cannot be the same for bonding mode mode.
This command is not supported for InfiniBand interfaces.
The specified Jumbo value already exists for the interface.
The specified interface does not support the specified speed and mode.
For interface -info:
The interface interface-name is not configured.
WARNING MESSAGES
For interface -modify:
Warning: SNMP configuration file /etc/default/snmpd is missing.
Warning: SNMP configuration file /etc/default/snmpd is corrupt.
Warning: Cannot restart SNMP daemon.
Warning: Cannot restart SNMP agents.
Warning: Cannot write to SNMP configuration file /etc/default/snmpd.
CONSIDERATIONS
Considerations for interface -add:
The bonding interface will find an entry as one of the interfaces, with the slave interfaces
configured within that bonding interface definition. Slave interfaces should not be added using
this command. Slave interfaces for a bonding interface can be configured using the command
climconfig slaveinterface -configure . . ..
The climconfig tool does not allow addition of a virtual interface other than eth0:0.
eth0:0 cannot be added when the CLIM is in the STARTED state.
If the interface to be added is UP, it should first be brought down using the CLIMCMD ifstop
command, and then added.
Considerations for interface -delete:
You cannot delete eth0, the dedicated service LAN interface.
lo, the loopback interface, cannot be deleted.
This command cannot be executed when the specified interface is active (UP). Use the CLIMCMD
ifstop command to deactivate the interface before deleting it.
An interface cannot be deleted before deleting any tunnel interface associated with it.
This command cannot be used to delete tunnel interfaces.
eth0:0, the maintenance provider interface, cannot be deleted when eth0:0 is in use by the
NonStop host.
Considerations for interface -modify:
You cannot modify the IP address and netmask of eth0 when the CLIM is in the STARTED state.
To modify the IP address on a CLIM, do a climcmd clim-name clim stop, then a
climcmd clim-name climconfig interface -modify eth0 -ipaddress new
318