Cluster I/O Protocols (CIP) Configuration and Management Manual (H06.16+, J06.05+)

4294967295. This option is used to improve performance on routes to SWAN concentrators,
with a recommended value of 7.
-default
Specifies to use the default route if no other route matches. This option is not valid with the
–host, –net, –netmask, and –target options.
-usrconfig
Valid only with the route -info command. This option displays user-configured routes only.
If this option is omitted, the command displays the user configured routes and the dynamic
routes added by the kernel.
-obeyform
Generates user-configured route (IPv4 and IPv6) information in add command format.
-force
If used without –force option, this command prompts for confirmation before deleting the
route.
-src
The source IP address to use for outgoing connections or UDP packets using this route if the
socket is not bound to an IP address. The option is useful if there is an interface with multiple
IP Addresses and it is desired that outgoing client connection requests or UDP packets using
that interface use a particular IP Address on that interface to the specified location. The –src
option is valid for IPv4 routes only.
This table shows possible option combinations for different route types:
-src–initcwnd–minrto–mt–gateway–netmask–target
optionaloptionaloptionaloptionaloptionaloptionalrequired–net
optionaloptionaloptionaloptionaloptionaloptionalrequired–host
optionaloptionaloptionaloptionalrequiredoptionaloptional–default
ERROR MESSAGES
For route -add:
This command is not supported for the interface lo.
The interface interface-name is not configured.
Configuring IPv6 route is not allowed for eth0 and eth0:0 interfaces.
The IPv4 family cannot be specified for the tunnel interface.
The specified route already exists for the interface-name.
The specified IP Address ip-address is not configured for interface-name
The –src parameter is not valid for an IPv6 route.
For route -delete:
The interface interface-name is not configured.
This command is not supported for the interface lo.
The specified route is not configured for the interface-name.
CONSIDERATIONS
Valid combinations of options for different route types for route -add and route -delete
are:
If the -net option is specified, then -target is required, and -netmask, -gateway, and
-mt (route -add only) are optional.
358