Cluster I/O Protocols (CIP) Configuration and Management Manual (H06.16+, J06.05+)

A SCF Error Messages
This appendix describes the CIP subsystem SCF error messages. Error messages are listed with
their accompanying subsystem programmatic interface (SPI) token.
For operator messages, see the Operator Messages Manual.
CIP 00001 (zcip-err-cmd-not-implemented)
CIP E00001 Command not implemented.
Cause
You entered a command that the CIP SCF product module does not support.
Effect
The SCF command is not executed.
Recovery
Check the SCF section of this manual for a list of supported commands.
CIP 00002 (zcip-err-internal-error)
CIP E00002 CIP SCF Product Module Internal Error - contact GCSC.
Cause
CIP SCF Product Module encountered an internal error.
Effect
The SCF command is not executed.
Recovery
This is a serious error. Send complete error information to your Global Customer Support Center
for analysis.
CIP 00003 (zcip-err-case-out-of-range)
CIP E00003 CIP SCF Product Module Internal Error: Case value out of range.
Cause
An invalid case value was generated with no associated case label.
Effect
The SCF command is not executed.
Recovery
This is a serious error. Send complete error information to your Global Customer Support Center
analyst for analysis.
CIP 00004 (zcip-err-cmd-attr-dup)
CIP E00004 Duplicate attribute specified.
Cause
You specified an attribute more than once in a command.
Effect
The SCF command is not executed.
Recovery
Omit the duplicate attribute and retry the command.
383