Cluster I/O Protocols (CIP) Configuration and Management Manual (H06.16+, J06.05+)

Recovery
Reissue SCF command without the CPU attribute.
NOTE: This is used internally by the SCF product module.
CIP 00029 (zcip-err-locksize-invalid)
CIP E00029 LOCKSIZE must be less than or equal to PAGES.
Cause
You issued a TRACE command with a LOCKSIZE value that was greater than the PAGES value.
Effect
The SCF command is not executed.
Recovery
Retry the command with a LOCKSIZE value that is less than or equal to the PAGES value. If
PAGES is not specified, LOCKSIZE must be less than or equal to 64 pages.
NOTE: This is used internally by the SCF product module.
CIP 00030 (zcip-err-cpu-attr-required)
CIP E00030 CPU attribute is required.
Cause
You issued a TRACE CLIM or TRACE PROVIDER command and specified the TO attribute but
not the CPU attribute.
Effect
The SCF command is not executed.
Recovery
Reissue the SCF command with the CPU attribute.
NOTE: This is used internally by the SCF product module.
CIP 00031 (zcip-err-context-invalid)
CIP E00031 Request contains invalid or obsolete context information.
Cause
Continuation of an SCF command happens with invalid or obsolete context information. This
can happen if too much time has elapsed between the initial request and command continuation.
Effect
The SCF command is not executed.
Recovery
Reissue the SCF command.
CIP 00032 (zcip-err-unsynch-mon)
CIP E00032 One or more CIPMON processes are out of synch.
Cause
An SCF request for configuration change (ADD, DELETE, or ALTER command) or state change
(START, STOP, or ABORT command) cannot be executed because the CIPMAN process cannot
communicate with one or more CIPMON processes to ensure consistency of CIP subsystem
configuration.
Effect
The SCF configuration or state change command is not executed.
391