Cluster I/O Protocols (CIP) Configuration and Management Manual (H06.16+, J06.05+)

mismatch for ending ephemeral port number0x80
Item defined in sysctl parameter net.ipv4.ip_local_port_range and PROVIDER share-ports value:
ephemeral port range start or end exceeds 655350x100
Item defined in sysctl parameter net.core.wmem_default:
mismatch for default socket send buffer0x200
Item defined in sysctl parameter net.core.wmem_max:
mismatch for maximum socket send buffer0x400
Item defined in sysctl parameter net.core.rmem_default:
mismatch for default socket receive buffer0x800
Item defined in sysctl parameter net.core.rmem_max:
mismatch for maximum socket receive buffer0x1000
ErrorDetail1 can be an accumulated value. If ErrorDetail1 is equal to 9 (1 + 8),
that means there is a mismatch between the minimum TCP receive buffer size and the minimum
TCP send buffer size. ErrorDetail2 and ErrorDetail3 will show the mismatch values
of the last case, that is, the minimum TCP send buffer size.
ErrorDetail2
Is the value of the ErrorDetail1 item set for the Provider.
ErrorDetail3
Is the mismatched value for the reporting CLIM.
Effect
The CLIM is not accessible from that processor.
Recovery
Make sure that TCP/IP parameters on all CLIMs associated with the same PROVIDER object are
identical. Also, make sure the ephemeral port ranges on all CLIMs associated with the same
PROVIDER object are the same and leave enough ports between maximum ephemeral port
number and maximum valid port number for the SHARE-PORTS.
Origin “CIPSREQ” Fault Code 3029
Cause
The CIP subsystem dynamic link library (ZCIPDLL) could not obtain sufficient memory to process
the addition of a new local IP address or new route provided by the CLIM.
Effect
The IP address or route is not added within the CIP subsystem dynamic link library (ZCIPDLL) in
that processor.
Recovery
None. The CIP subsystem should automatically recover. If this problem persists, make sure
sufficient QIO memory is available. If this problem still persists, report the problem to your HP
service provider for analysis.
Origin “CIPSREQ” Fault Code 3030
Cause
The CIP subsystem dynamic link library (ZCIPDLL) encounters an error when it attempts to
communicate with MEASURE.
• ErrorDetail1 = -1 indicates MEASURE is too old to support the CIP subsystem.
• ErrorDetail1 = 1 indicates MEASURE is too busy to process this request.
409