Cluster I/O Protocols (CIP) Configuration and Management Manual (H06.16+, J06.05+)

Origin “CLIMAGT” Fault Code 5152
Cause
The interface activation failed. This can be caused by an interface configuration problem, the
interface still being active on a different CLIM, or other internal problems.
Effect
The current CLIM request failed. The current CLIM request failed. The specified interface cannot
be brought to the active state.
Recovery
Make sure the CLIM has correct and valid configuration information (by using the climconfig
command). Otherwise, the CIP subsystem should automatically recover. If problem persists, send
complete information (including the CLIM’s syslog information) to your HP support provider for
analysis.
Origin “CLIMAGT” Fault Code 5184
Cause
The CLIM is running a new version of CLIM software and is configured for multiple Providers
(MULTIPROV ON) but the NonStop system is running an older version of CIP Subsystem software
that does not support MULTIPROV capability.
Effect
The current CLIM request failed. The CLIM cannot move to STARTED state.
Recovery
Make sure that the NonStop system is running a newer version of the CIP subsystem software
that supports MULTIPROV capability.
Origin “ITAPI” Fault Code 9
Cause
The underlying connection between a NonStop host processor and a CLIM breaks.
Effect
That CLIM is not accessible from that NonStop host processor.
Recovery
The CIP subsystem should automatically attempt to re-establish an iT-API connection. If the problem
persists, the CLIM may be hung. In that case, a CLIM reboot is recommended.
Origin “ITAPI” Fault Code 8195
Cause
The IT-API connection between a NonStop host system processor and a CLIM has been
disconnected. (IT-API is the transport connection between the NonStop host system and the CLIM.)
Effect
That CLIM is not accessible from that NonStop host system processor.
Recovery
The CIP subsystem should automatically attempt to re-establish the IT-API connection. If the problem
persists, make sure the CLIM is correctly configured. If the problem is related to a memory
problem, reboot the CLIM.
Origin “ITAPI” Fault Code 8196
Cause
A CLIM process has rejected an IT-API connection establishment. This can be caused by running
out of resources or a mismatch between the version of software on the NonStop host system and
on CLIM.
414 Fault Codes