Cluster I/O Protocols (CIP) Configuration and Management Manual (H06.16+, J06.05+)

N1002532 IP (100 ,2 ,5 ,3 ,2) 1 ZTC01 OFF
N1002531 IP (100 ,2 ,5 ,3 ,1) 1 ZTC01 OFF
Configure two-way failover for the bond1 and eth4 interfaces from source N1002532 to target
N1002531:
> CLIMCMD N1002532 climconfig failover –add bond1 -dest N1002531.bond1
> CLIMCMD N1002532 climconfig failover –add eth4 -dest N1002531.eth4
> CLIMCMD N1002531 climconfig failover –add bond1 -dest N1002532.bond1
> CLIMCMD N1002531 climconfig failover –add eth4 -dest N1002532.eth4
Check Network Applications (Does Not Apply to Storage CIP)
Check the LISTNER and TELSERV processes.
From the SCF prompt, issue the LISTOPENS MON commands:
> LISTOPENS MON $ZZCIP.*
This command displays all the processes that are using the CIP subsystem, including the LISTNER
and TELSERV processes.
68 Quick Start