Cluster I/O Protocols (CIP) Configuration and Management Manual (H06.16+, J06.05+)

Figure 22 Configuration State
8. Configure failover on C1002581:
> CLIMCMD C1002581 climconfig failover –add bond0 –dest C1002582.bond0c
9. Configure LAN B.
> CLIMCMD c1002581 climconfig ip -add bond0 -ipaddress 10.13.100.21 netmask 255.0.0.0
> CLIMCMD c1002581 climconfig ip -add bond1 -ipaddress 10.14.100.22 -netmask 255.0.0.0
10. Configure LAN C
> CLIMCMD C1002582 climconfig interface –add eth2
> CLIMCMD C1002582 climconfig ip –add eth2 –ipaddress 10.25.100.31 –netmask 255.0.0.0
> CLIMCMD C1002582 climconfig ip –add eth2 –ipaddress 10.26.100.32 –netmask 255.0.0.0
Figure 23: Configuration State shows the state of the configuration at this point:
98 CIP Configuration and Management