Expand Configuration and Management Manual (H06.21+, J06.10+)

Configuration Overview
Expand Configuration and Management Manual — 529522-013
5 - 2
Summary of Configuration Steps
Summary of Configuration Steps
Configuring the Expand subsystem involves a number of steps. Table 5-1 lists each
step and indicates where in this manual the step is described.
Table 5-1. Configuration Steps
Step Description Where This Step Is Described
1. Start the Expand manager
pro
cess.
For step 1, information is located in Starting the
Expand Manager Process on page 5-4 of this
section.
2.
3.
Create a profile for the
ne
twork control process at
each node in the Expand
network.
Create and start the
ne
twork control process at
each node in the Expand
network.
For steps 2 and 3, information is located in
Section
6, Configuring the Network Control
Process.
4.
5.
6.
Create profiles for the
Exp
and line-handler
processes.
Create and start the Expand
line-ha
ndler processes.
Start the Expand lines.
For steps 4 through 6, information is located in one
of t
hese sections. Which section you select
depends on the type of Expand line-handler
process that you want to configure:
Section
7, Configuring Direct-Connect and Satellite-
Connect Lines
Section 8, Configuring Expand-Over-IP Lines
Section 9, Configuring Expand-Over-ATM Lines
Section 10, Configuring Expand-Over-X.25 Lines
Section 11, Configuring Expand-Over-SNA Lines
Section 12, Configuring Expand-Over-ServerNet
Lines
Section 13, Configuring Multi-Line Paths