Expand Configuration and Management Manual (H06.21+, J06.10+)

Configuring Direct-Connect and Satellite-Connect
Lines
Expand Configuration and Management Manual — 529522-013
7 - 9
ADD DEVICE Command
IOPOBJECT $SYSTEM.SYSnn.LHOBJ
is the name of the object file containing the executable object for code for an
Expand line-handler process. This value must be $SYSTEM.SYSnn.LHOBJ.
PROFILE profile_name
is the name of the profile you created for this Expand line-handler process in Step
2: Create a Profile for the Line-Handler Process.
CPU cpunumber
indicates the processor where this Expand line-handler process will normally run.
HP recommends that you specify the same processor as that configured for the
preferred NonStop TCP/IP process used by the SWAN concentrator specified by
concname.
ALTCPU altcpunumber
indicates the processor where the backup Expand line-handler process will
normally run. HP recommends that you specify the same processor as that
configured for the alternate NonStop TCP/IP process used by the SWAN
concentrator specified by concname.
TYPE (63,5)
is the device type and subtype for this Expand line-handler process. The device
type is always 63 for Expand line-handler processes. The subtype is 5 for both
single-line direct-connect and satellite-connect line-handler processes.
RSIZE rsize
specifies the time factor of the line for the Expand routing algorithm. RSIZE can be
0 if the time factor is set using some other modifier.
ADAPTER concname
is the SWAN concentrator you selected for use by this Exp
and line-handler
process in Step 1: Find an Available WAN Line on page 7-5.
CLIP clipnum
is the CLIP number on the SWAN concentrator specified by concname that
contains an available WAN line. For more information on identifying CLIP values,
see Step 1: Find an Available WAN Line on page 7-5.
LINE linenum
is the number of an available WAN line on the CLIP specified by clipnum. For
more information on identifying line numbers, see
Step 1: Find an Available WAN
Line on page 7-5. Valid values are 0 or 1.