Expand Configuration and Management Manual (H06.21+, J06.10+)

Configuring Expand-Over-IP Lines
Expand Configuration and Management Manual — 529522-013
8 - 8
Summary of Configuration Steps
Summary of Configuration Steps
After all hardware and software requirements have been met (see Required Hardware
and Software on page 8-2 for details), configuring and starting a single-line Expand-
over-IP line-handler process involves these steps. Use Steps A or B depending on
which version of TCP/IP you want to use.
Step Tool Used
Step 1 (A): Select a Process and SUBNET for NonStop
TCP/IP Use
SCF interface to the
NonStop TCP/IP
subsystem
Step 1 (B): Select a Process and SUBNET for NonStop
TCP/IPv6 Use
SCF interface to the
NonStop TCP/IPv6
subsystem
Step 1 (C): Select a Process and SUBNET for CIP Use SCF interface to the CIP
subsystem
Step 2 (A): Identify an Available UDP Port Number SCF interface to the
NonStop TCP/IP
subsystem
Step 2 (B): Identify an Available UDP Port Number for Non-
Stop TCP/IPv6 Use
SCF interface to the
NonStop TCP/IPv6
subsystem
Step 2 (C): Identify an available UDP Port Number for CIP Use SCF interface to the CIP
subsystem
Step 3: Create a Profile for the Line-Handler Process SCF interface to the WAN
subsystem
Step 4: Create the Line-Handler Process SCF interface to the WAN
subsystem
Step 5: Start the Line-Handler Process SCF interface to the WAN
subsystem
Step 6: Start the Line SCF interface to the
Expand subsystem
Note. The SCF command syntax shown in this section is the syntax used to configure
Exp
and-over-IP line-handler processes; it is not meant to show the complete syntax of SCF
commands described. For more information, see these manuals:
•
TCP/IP Configuration and Management Manual
•
TCP/IPv6 Configuration and Management Manual
•
Cluster I/O Protocols (CIP) Configuration and Management Manual
•
WAN Subsystem Configuration and Management Manual
•
Section 14, Subsystem Control Facility (SCF) Commands