Expand Configuration and Management Manual (H06.21+, J06.10+)

Configuring Expand-Over-IP Lines
Expand Configuration and Management Manual — 529522-013
8 - 11
Step 1 (B): Select a Process and SUBNET for
NonStop TCP/IPv6 Use
After the SUBNET is defined, it must be started using the SCF START SUBNET
command. This SCF START SUBNET command shown starts the SUBNET named
#SN1:
-> START SUBNET $ZTC01.#SN1
For more information on creating SUBNETs, see the TCP/IP Configuration and
Management Manual.
Step 1 (B): Select a Process and SUBNET for
NonStop TCP/IPv6 Use
Step 1 (B) is for use with NonStop TCP/IPv6 only.
Select a SUBNET for NonStop TCP/IPv6 Use
NonStop TCP/IPv6 only supports SUBNETs of type Ethernet. A NonStop TCP/IPv6
SUBNET associates the NonStop TCP/IPv6 environment with a connection to a
network and an IP address.
To obtain a list of running IPv6 and IPv6 SUBNETs, issue this SCF command:
> INFO SUBNET $ZZTCP.*, DETAIL
Note. You must also perform this step on the destination system before you can define the
local Expand-over-IP line-handler process. The destination IP address must be specified when
the local Expand-over-IP line-handler process is defined.
Note. These instructions assume that a NonStop TCP/IPv6 environment has already been
st
arted. For more information on starting a NonStop TCP/IPv6 environment, see the TCP/IPv6
Configuration and Management Manual.
Note. For NonStop TCP/IPv6, we use the SCF INFO SUBNET command to the manager
pro
cess ($ZZTCP) for the example because it shows IPv6 address whereas the SCF INFO
SUBNET command to the TCP6SAM process shows only IPv4 addresses. If you are using
NonStop TCP/IPv6 in INET mode (IPv4 addresses only), you can issue the INFO SUBNET
command to the TCP6SAM process.