Expand Configuration and Management Manual (H06.21+, J06.10+)

Configuring Expand-Over-IP Lines
Expand Configuration and Management Manual — 529522-013
8 - 16
Obtain an IP Address to associate with your Expand
Line- Handler Process
You must specify the IP address associated with an Ethernet SUBNET when you
define the SRCIPADDR modifier for the Expand-over-IP line-handler process in Step 4:
Create the Line-Handler Process.
In this example, we use SUBNET #SN0002 and its IP address, 172.17.190.101.
Example 8-6. SCF INFO SUBNET $ZSAM0
CIP Info SUBNET $\MYSYS.$ZSAM0.*
Name Devicename *IPADDRESS TYPE *SUBNETMASK SuName QIO *R
#SN0001 lo 127.0.0.1 LOOP-BACK %HFF000000 OFF N
#SN0002 DL395N.eth1 172.17.190.101 ETHERNET %HFFFFFF00 ON N
#SN0003 DL385N.ETH2 172.17.190.102 ETHERNET %HFFFFFF00 ON N
#SN0004 DL385N.ETH3 172.17.190.103 ETHERNET %HFFFFFF00 ON N
#SN0005 DL385N.ETH4 172.17.190.104 ETHERNET %HFFFFFF00 ON N
#SN0007 DL385Q.BOND0 172.17.190.81 ETHERNET %HFFFFFF00 ON N
#SN0008 DL385Q.BOND1 172.17.190.83 ETHERNET %HFFFFFF00 ON N
Note. Only IPv4 addresses are displayed with the CIP SCF INFO SUBNET command. If you
want to use an IPv6 address, obtain one by using the SCF STATUS CLIM, DETAIL command.
This command displays both IPv4 and IPv6 addresses configured on each interface.