Expand Configuration and Management Manual (H06.21+, J06.10+)

Configuring Expand-Over-IP Lines
Expand Configuration and Management Manual — 529522-013
8 - 24
ADD DEVICE Command
PROFILE profile_name
is the name of the profile you created for this Expand line-handler process in Step
3: Create a Profile for the Line-Handler Process.
CPU cpunumber
indicates the processor where this Expand line-handler process runs. This must be
the same processor as configured for the primary NonStop TCP/IP process.
If you are using NonStop TCP/IPv6 or CIP, you need not have the line-handler on
the same CPU as the TCP6SAM or CIPSAM process. There is typically a monitor
process in each CPU. The line-handler process must be on the CPU that contains
a monitor process.
ALTCPU altcpunumber
indicates the processor where the backup Expand line-handler process runs. This
must be the same processor as that configured for the NonStop TCP/IP process.
If you are using NonStop TCP/IPv6 or CIP, you need not have the line-handler on
the same CPU as the TCP6SAM or CIPSAM process. There is typically a monitor
process in each CPU. The line-handler process must be on the CPU that contains
a monitor process.
TYPE (63,0)
is the device type and subtype for this Expand line-handler process. The device
type is always 63 for Expand line-handler processes. The subtype is 0 for single-
line Expand-over-IP line-handler processes.
RSIZE rsize
specifies the time factor of the line for the Expand routing algorithm. RSIZE can be
0 if the time factor is set using some other modifier.
ASSOCIATEDEV tcpip_process
is a required modifier that specifies the device name of the NonStop TCP/IP,
CIPSAM, or TCP6SAM process you want to associate with this Expand-over-IP
line-handler process. The NonStop TCP/IP process must be configured in the
same processor pair as the Expand-over-IP line-handler process. There is no
default name.
{IPVER_IPV4 | IPVER_IPV6}
specifies whether the destination and source addresses are IPv4 or IPv6. The
default is IPv4. DESTIP
ADDR and SRCIPADDR are required if IPVER is IPV4 (the
default). V6DESTIPADDR and V6SRCIPADDR are required if IPVER is IPV6. (This
attribute applies to NonStop TCP/IPv6 and CIP only.)