Expand Configuration and Management Manual (H06.21+, J06.10+)

Configuring Expand-Over-IP Lines
Expand Configuration and Management Manual — 529522-013
8 - 25
ADD DEVICE Command
SRCIPADDR src_ipaddr
if IPVER is IPv4 (the default), this is a required modifier that specifies an IP
address associated with the NonStop TCP/IP, CIPSAM, or TCP6SAM process
used by this Expand-over-IP line-handler process. This is the IP address you
selected in Step 1 (A): Select a Process and SUBNET for NonStop TCP/IP Use,
Step 1 (B): Select a Process and SUBNET for NonStop TCP/IPv6 Use, or Step 1
(C): Select a Process and SUBNET for CIP Use. The address must be specified by
number (for example, 130.252.12.3). It is not validated and need not be
accessible. The default address is 0.0.0.1.
SRCIPPORT src_ipport
is a required modifier that specifies the UDP port number used by this Expand-
over-IP line-handler process. This is the port number you selected in Step 2 (A):
Identify an Available UDP Port Number, Step 2 (B): Identify an Available UDP Port
Number for NonStop TCP/IPv6 Use, or Step 2 (C): Identify an available UDP Port
Number for CIP Use. Valid values are in the range 0 through 65534. The default is
1024. HP recommends that you do not use a well-known port in the range from 0
through 1023.
DESTIPADDR dest_ipaddr
if IPVER is IPv4 (the default), this is a required modifier that specifies the IP
address used by the remote (destination) Expand-over-IP line-handler process. It
is the IP address specified in the remote line-handler process’ SRCIPADDR
modifier. dest_ipaddr must be specified by number (for example,
130.252.12.3). Selecting IP addresses is described in Step 1 (A): Select a
Process and SUBNET for NonStop TCP/IP Use, Step 1 (B): Select a Process and
SUBNET for NonStop TCP/IPv6 Use, and Step 1 (C): Select a Process and
SUBNET for CIP Use. It is not validated and need not be accessible. The default
address is 0.0.0.1.
DESTIPPORT dest_ipport
is a required modifier that specifies the UDP port number used by the remote
(destination) Expand-over-IP line-handler process. It is the port number specified in
the remote line-handler process’ SRCIPPORT modifier. Selecting port numbers is
described in
Step 2 (A): Identify an Available UDP Port Number, Step 2 (B): Identify
an Available UDP Port Number for NonStop TCP/IPv6 Use, and Step 2 (C): Identify
an available UDP Port Number for CIP Use. Valid values are in the range 0
through 65534. The default value is 1024. HP recommends that you do not use a
well-known port in the range from 0 through 1023.
V6SRCIPADDR v6srcip-address
if IPVER is IPv6, this is a required modifier that specifies an IP address associated
with the TCP6SAM process used by this Expand-over-IP line-handler process.
This is the IP address you selected in
Step 1 (B): Select a Process and SUBNET
for NonStop TCP/IPv6 Use or Step 1 (C): Select a Process and SUBNET for CIP