Expand Configuration and Management Manual (H06.21+, J06.10+)

Configuring Expand-Over-ATM Lines
Expand Configuration and Management Manual — 529522-013
9 - 5
Summary of Configuration Steps
Summary of Configuration Steps
After all hardware and software requirements have been met (see Required Hardware
and Software on page 9-2 for details), configuring and starting a single-line Expand-
over-ATM line-handler process involves these steps:
Step 1: Identify the ATM Connection
The ATM subsystem provides permanent virtual circuit (PVC), switched virtual
circuit (SVC),
or ATM protocol direct service access point (ATMSAP) connections.
A PVC connection is permanently established while an SVC connection is dynamically
established. An ATMSAP connection uses the ServerNet LAN systems access (SLSA)
subsystem, but is the same type of connection as PVC.
You configure your Expand-over-A
TM line-handler process differently depending on
whether it will use a PVC, SVC, or ATMSAP connection.
Step Tool Used
Step 1: Identify the ATM Connection SCF interface to the ATM subsystem
Step 2: Create a Profile for the Line-Handler Process SCF interface to the WAN
subsystem
Step 3: Create the Line-Handler Process SCF interface to the WAN
subsystem
Step 4: Start the Line-Handler Process SCF interface to the WAN
subsystem
Step 5: Start the Line SCF interface to the Expand
subsystem
Note. The SCF command syntax shown in this section is the syntax used to configure
Exp
and-over-ATM line-handler processes; it is not meant to show the complete syntax of SCF
commands described. For more information, see:
•
ATM Configuration and Management Manual for ATM subsystem commands
•
WAN Subsystem Configuration and Management Manual for WAN subsystem SCF
commands
•
Subsystem Control Facility (SCF) Commands, for Expand subsystem SCF commands
Note. This procedure assumes that an ATM3SA has already bee
n installed and configured.
For complete information about installing and configuring an ATM3SA, see the ATM
Configuration and Management Manual.