Expand Configuration and Management Manual (H06.21+, J06.10+)

Configuring Expand-Over-X.25 Lines

Expand Configuration and Management Manual — 529522-013

10 - 6

Summary of Configuration Steps

After all hardware and software requirements have been met (see Required Hardware

and Software on page 10-2 for details), configuring and starting a single-line Expand-

over-X.25 line-handler process involves these steps.

Step Tool Used

Step 1: Add a NAM Subdevice to the X25AM Line SCF interface to the X25AM

subsystem

Step 2: Start the X25AM Line SCF interface to the X25AM

subsystem

Step 3: Create a Profile for the Expand-Over-X.25 Line-

Handler Process

SCF interface to the WAN

subsystem

Step 4: Create the Expand-Over-X.25 Line-Handler

Process

SCF interface to the WAN

subsystem

Step 5: Start the Expand-Over-X.25 Line-Handler Process SCF interface to the WAN

subsystem

Step 6: Start the Expand-Over-X.25 Line SCF interface to the Expand

subsystem

Note. The SCF command syntax shown in this section is the syntax used to configure

Exp

and-over-X.25 line-handler processes; it is not meant to show the complete syntax of the

SCF commands described. For more information, see:

•

X25AM Configuration and Management Manual for X25AM subsystem SCF commands

•

WAN Subsystem Configuration and Management Manual for WAN subsystem SCF

commands

•

Section 14, Subsystem Control Facility (SCF) Commands, for Expand subsystem SCF

commands