Expand Configuration and Management Manual (H06.21+, J06.10+)

Configuring Expand-Over-X.25 Lines
Expand Configuration and Management Manual — 529522-013
10 - 8
Step 3: Create a Profile for the Expand-Over-X.25
Line-Handler Process
Step 3: Create a Profile for the Expand-Over-
X.25 Line-Handler Process
You can create a profile for a single-line Expand-over-X.25 line-handler process using
the PEXQSNAM profile. This profile is provided in the $SYSTEM.SYSnn subvolume.
You can also create a new profile from an existing profile, or you can create your own
profile. For complete information about profiles, see the WAN Subsystem Configuration
and Management Manual.
This subsection describes how to create a profile using PEXQSNAM.
ADD Profile Command
To create a profile from the PEXQSNAM profile template, use the WAN subsystem
SCF ADD PROFILE command. The command syntax is:
$ZZWAN.profile_name
specifies, via the WAN subsystem, a user-defined name of up to 8 alphanumeric
characters that will be used to identify the new profile. You will reference this
profile_name when you create a device for the line-handler process in Step 4:
Create the Expand-Over-X.25 Line-Handler Process.
FILE
$SYSTEM.SYSnn.profile_filename
specifies the name of an existing disk file that will be used to create the new
profile. PEXQSNAM is the disk filename of the profile provided for Expand-over-
NAM line-handler processes.
modifier_keyword
is the name of a modifier in profile_name. Modifier names in the PEXQSNAM
profile are listed in Profile Modifiers on page 10-13.
modifier_value
is the value you want to assign to the modifier specified by modifier_keyword.
Specifying a modifier_value assigns a new value to modifier_keyword in
profile_name. Default values and ranges of values for modifiers in the
PEXQSNAM profile are described in Profile Modifiers on page 10-13.
Note. Different profiles are provided for Expand-over-X.25 lines that are part of a multi-line
path; these profiles are described in Section
13, Configuring Multi-Line Paths.
ADD PROFILE $ZZWAN.#profile_name
, FILE $SYSTEM.SYSnn.profile_filename
[, modifier_keyword [ modifier_value ] ] ...