Expand Configuration and Management Manual (H06.21+, J06.10+)

Configuring Expand-Over-X.25 Lines
Expand Configuration and Management Manual — 529522-013
10 - 12
Step 5: Start the Expand-Over-X.25 Line-Handler
Process
Step 5: Start the Expand-Over-X.25
Line-Handler Process
To start a single-line Expand-over-X.25 line-handler process, use the WAN subsystem
SCF START DEVICE command. The command syntax is:
$ZZWAN.device_name
specifies, via the WAN subsystem, the device name of the Expand-over-X.25
line-handler process.
This command creates the specified Expand line-handler process and allocates a
logical device (LDEV) number.
Step 6: Start the Expand-Over-X.25 Line
To start an Expand-over-X.25 line, use the Expand subsystem SCF START LINE
command. The command syntax is:
device_name
is the device name of the Expand-over-X.25 line-handler process.
The successful completion of this command leaves the line in the STARTED state.
START DEVICE $ZZWAN.#device_name
START LINE $device_name