Expand Configuration and Management Manual (H06.21+, J06.10+)

Configuring Expand-Over-SNA Lines
Expand Configuration and Management Manual — 529522-013
11 - 9
Example
Example
Figure 11-3 shows the SCF commands used to configure a SNAX/APN line, local LU,
remote PU, and remote LU at two nodes in an Expand network.
Figure 11-3. SNAX/APN Line Configuration Example
VST050.vsd
SNA Network
SWAN
SWAN
System \A
System \B
Expand
Line-Handler
Process
SNAX/APN
Line-Handler
Process
($SNAPA)
SNAX/APN
Line-Handler
Process
($SNASB)
Expand
Line-Handler
Process
SCF Commands for System \A
ADD LINE $SNAPA
, RECSIZE 524
, MAXPUS 1
, MAXLUS 30
, STATION PRIMARY
, MAXLOCALLUS 10
, POLLINT 0.01
ADD LU $SNAPA.#LLUA
, TYPE (14,21)
, SNANAME LUA
, PROTOCOL NAM
, DLUNAME #RLUA
, RSPTYPE ER
ADD PU $SNAPA.#RPUA
, TYPE (13,21)
, ADDRESS %HC1
, RECSIZE 521
, MAXLUS 30
ADD LU $SNAPA.#RLUA
, SNANAME LUB
, PUNAME #RPUA
SCF Commands for System \B
ADD LINE $SNASB
, RECSIZE 524
, MAXPUS 1
, MAXLUS 30
, STATION SECONDARY
, MAXLOCALLUS 10
ADD LU $SNASB.#LLUB
, TYPE (14,21)
, SNANAME LUB
, PROTOCOL NAM
, DLUNAME #RLUB
, RSPTYPE ER
ADD PU $SNASB.#RPUB
, TYPE (13,21)
, ADDRESS %HC1
, RECSIZE 521
, MAXLUS 30
ADD LU $SNASB.#RLUB
, SNANAME LUA
, PUNAME #RPUB
Local LU SNANAME
and remote LU SNANAME
must match
Local LU DLUNAME
and remote LU
subdevice
name must match