Expand Configuration and Management Manual (H06.21+, J06.10+)

Configuring Expand-Over-SNA Lines
Expand Configuration and Management Manual — 529522-013
11 - 1 0
Step 3: Start the SNAX/APN Line
Step 3: Start the SNAX/APN Line
Before you can start the Expand-over-SNA line, the SNAX/APN line (and its associated
PUs and LUs) must be started. To start a SNAX/APN line, use the SNAX/APN
subsystem SCF START LINE command. This command starts a SNAX/APN line
named $SNAPA and its associated PUs and LUs:
-> START LINE $SNAPA, SUB ALL
For details about starting SNAX/APN lines, see the SNAX/XF and SNAX/APN
Configuration and Management Manual.
Step 4: Create a Profile for the Expand-Over-
SNA Line-Handler Process
You can create a profile for a single-line Expand-over-SNA line-handler process using
the PEXQSNAM profile. This profile is provided in the $SYSTEM.SYSnn subvolume.
You can also create a new profile from an existing profile, or you can create your own
profile. For complete information about profiles, see the WAN Subsystem Configuration
and Management Manual.
This subsection shows you how to create a profile using PEXQSNAM.
ADD Profile Command
To create a profile from the PEXQSNAM profile template, use the WAN subsystem
SCF ADD PROFILE command. The command syntax is:
$ZZWAN.profile_name
specifies, via the WAN subsystem, a user-defined name of up to eight
alphanumeric characters that will be used to identify the new profile. You will
reference this profile_name when you create a device for the line-handler
process in Step 5: Create the Expand-Over-SNA Line-Handler Process.
FILE $SYSTEM.SYSnn.profile_filename
specifies the name of an exi
sting disk file that will be used to create the new
profile. PEXQSNAM is the disk filename of the profile provided for Expand-over-
NAM line-handler processes.
Note. Different profiles are provided for Expand-over-SNA lines that are part of a multi-line
path; these profiles are described in Section
13, Configuring Multi-Line Paths.
ADD PROFILE $ZZWAN.#profile_name
, FILE $SYSTEM.SYSnn.profile_filename
[, modifier_keyword [ modifier_value ] ] ...