Expand Configuration and Management Manual (H06.21+, J06.10+)

Configuring Expand-Over-ServerNet Lines
Expand Configuration and Management Manual — 529522-013
12 - 7
Summary of Configuration Steps
Summary of Configuration Steps
After all hardware and software requirements have been met (see Required Hardware
and Software on page 12-2 for details), configuring Expand-over-ServerNet
connections involves these steps:
Configuring a ServerNet Node
To prepare an Integrity NonStop NS-series server to become a node in a ServerNet
cluster, see the guided procedure online help, which:
•
Creates a ServerNet cluster for the first time
•
Adds a node to an already configured ServerNet cluster
Step Tool Used
Step 1: Create a Profile for the Expand-Over-
ServerNet Line-Handler Process
SCF interface to the WAN
subsystem
Step 2: Create a Device for the Expand-Over-
ServerNet Line-Handler Process
SCF interface to the WAN
subsystem
Step 3: Start the Expand-Over-ServerNet Line-Handler
Processes
SCF interface to the WAN
subsystem
Step 4: Start the Expand-Over-ServerNet Lines SCF interface to the Expand
subsystem.
Note. The SCF command syntax shown in this subsection is the syntax used to configure
Exp
and-over-ServerNet connections; it is not meant to show the complete syntax of SCF
commands described. For more information, see:
•
WAN Subsystem Configuration and Management Manual for WAN subsystem SCF
commands
•
Section 14, Subsystem Control Facility (SCF) Commands, for Expand subsystem SCF
commands
Note. The Integrity NonStop NS1000 server does not support ServerNet clusters.