Expand Configuration and Management Manual (H06.21+, J06.10+)

Configuring Multi-Line Paths
Expand Configuration and Management Manual — 529522-013
13 - 11
ADD DEVICE Command
DESTIPADDR dest_ipaddr
is a required modifier that specifies the IP address used by the remote
(destination) Expand-over-IP line. It is the IP address specified in the remote line’s
SRCIPADDR modifier. Determining IP addresses is described in Step 1 (A): Select
a Process and SUBNET for NonStop TCP/IP Use on page 8-9. The address must
be specified by number (for example, 130.252.12.3). It is not validated and need
not be accessible. The default is 0.0.0.1.
DESTIPPORT dest_ipport
is a required modifier that specifies the port number used by the remote
(destination) Expand-over-IP line. It is the port number specified in the remote line-
handler process’ SRCIPPORT modifier. Determining port numbers is described in
Step 2 (A): Identify an Available UDP Port Number on page 8-17. Valid values are
in the range 0 through 65534. The default is 1024. HP recommends that you do
not use a well-known port in the range from 0 through 1023.
V6DESTIPADDR v6dest_ipport
is a required modifier that specifies the IP address used by the remote NonStop
TCP/IPv6 (destination) Expand-over-IP line. It is the IP address specified in the
remote line’s V6SRCIPADDR modifier. Determining IP addresses is described in
Step 1 (B): Select a Process and SUBNET for NonStop TCP/IPv6 Use on
page 8-11. The address must be specified by number (for example,
1611:1071:F881:1167:1611:A071:1881:B167). It is not validated and need not be
accessible. The default is 0000:0000:0000:0000:0000:0000:0000:0000.
V6SRCIPADDR v6src_ipaddr
is a required modifier that specifies the IP address associated with the NonStop
TCP/IPv6 process used by this Expand-over-IP line-handler process. Determining
IP addresses is described in Step 1 (B): Select a Process and SUBNET for
NonStop TCP/IPv6 Use on page 8-11. The address must be specified by number
(for example, 31CA:B145:5489:1034:1784:B245:4029:1257). It is not validated and
need not be accessible. The default is
0000:0000:0000:0000:0000:0000:0000:0000.
Required Modifiers for Expand-Over-ATM Lines
ASSOCIATESUBDEV #IP
identifies the ATM service access point (SAP). The only currently supported A
TM
SAP is #IP.
CALLTYPE_ATMSAP
indicates that the ATMSAP connection through the SLSA subsystem will be used.
Either CALL
TYPE_ATMSAP, CALLTYPE_PVC, or CALLTYPE_SVC is required.