Expand Configuration and Management Manual (H06.21+, J06.10+)

Configuring Multi-Line Paths
Expand Configuration and Management Manual — 529522-013
13 - 12
ADD DEVICE Command
CALLTYPE_PVC
indicates that a permanent virtual circuit (PVC) connection will be used. Either
CALLTYPE_ATMSAP, CALLTYPE_PVC, or CALLTYPE_SVC is required.
CALLTYPE_SVC
indicates that a switched virtual circuit (SVC) connection will be used. Either
CALLTYPE_ATMSAP, CALLTYPE_PVC, or CALLTYPE_SVC is required.
LIFNAME lif_name
is the name of the ATMSAP connection that will be used. For example, LIF01.
Identifying LIF names is described in Configuring an Expand Line-Handler Process
That Uses ATMSAP on page 9-9.
This modifier is only applicable to Expand-over-ATM line-handler processes that
use ATMSAP connections.
PVCNAME pvc_name
is the name of the PVC connection that will be used. For example, PVC01.
Identifying PVC names is described in Configuring an Expand Line-Handler
Process That Uses a PVC on page 9-6.
This modifier is only applicable to Expand-over-ATM line-handler processes that
use PVC connections.
ATMSEL selector_byte
is a hexadecimal selector byte for the ATM line used by this Expand-over-ATM line-
handler process. Obtaining selector bytes is described in Obtaining Selector Bytes
for the Local and Remote ATM Lines on page 9-6.
This modifier is only applicable to Exp
and-over-ATM line-handler processes that
use SVC connections.
DESTATMADDR (ISONSAP:%Hatm_address)
is the 20-byte ATM address configured for the ATM line used by the Expand-over-
ATM line-handler process at the remote system. The address must be preceded by
the characters ISONSAP:%H and must be enclosed in parentheses. For example:
(ISONSAP:%H47000580FFE1000000F21A29EB0000000001B300)
Identifying ATM addresses is described in
Identifying the ATM Address Configured
for the Remote ATM Line on page 9-7.
This modifier is only applicable to Expand-over-ATM line-handler processes that
use SVC connections.