Expand Configuration and Management Manual (H06.21+, J06.10+)

Configuring Multi-Line Paths
Expand Configuration and Management Manual — 529522-013
13 - 14
Step 6: Start the Lines
Step 6: Start the Lines
To start all the lines in the multi-line path, use the Expand subsystem SCF START
PATH command. The command syntax is:
device_name
is the path-logical device name.
The successful completion of this command leaves the path and all the lines in the
path in the STARTED state.
Starting Specific Lines
To start specific lines in a multi-line path, use the Expand subsystem SCF START LINE
command. The command syntax is:
device_name
is the line-logical device name.
The successful completion of this command leaves the specified line and its
associated path in the STARTED state. Other lines in the multi-line path are not
started.
START PATH $device_name
START LINE $device_name