Expand Configuration and Management Manual (H06.21+, J06.10+)

Configuring Multi-Line Paths
Expand Configuration and Management Manual — 529522-013
13 - 18
Line-Logical Device Modifiers
Line-Logical Device Modifiers
This subsection lists the modifiers for line-logical devices and describes the default
value and range of values for each modifier in the PEXQMSWN, PEXQMNAM,
PEXQMSAT, PEXQMATM, and PEXQMIP profiles. For a complete description of the
modifiers listed in this subsection, see Section 16, Expand Modifiers.
X25AM Process Modifiers
You might need to set this X25AM modifier when configuring an X25AM process to be
used by an Expand-over-X.25 line. This modifier is described in detail in the X25AM
Configuration and Management Manual.
L3WINDOW n
Default: 2
Units: Packets
Range: 1 through 15 (L3MOD128), 1 through 7 (L3MOD8)
This modifier specifies the number of packets that can be outstanding without an
acknowledgment from the network. You should set L3WINDOW to the largest possible
value.
PEXQMSWN and PEXQMSAT Modifiers
The disk file $SYSTEM.SYSnn.PEXQMSWN defines modifiers for direct-connect lines in
multi-line paths. The disk file $SYSTEM.SYSnn.PEXQMSAT defines modifiers for
satellite-connect lines in multi-line paths. Table
13-4 lists the default value and range of
values for each modifier in this profile, if applicable. For modifiers that are mutually
exclusive, a check mark (3) is shown in the “Default Value” column to indicate which
modifier is present in the profile.
Note. There are no required modifiers for direct-connect and satellite-connect lines in a multi-
line path.
Note.
Some X.25 networks limit the size of L3WINDOW. Consult your vendor for more
information.
Table 13-4. PEXQMSWN and PEXQMSAT Modifiers (page 1 of 2)
Modifier Default Value Range of Values
CLOCKMODE_DCE 3
CLOCKMODE_DTE
CLOCKSPEED_600
CLOCKSPEED_1200
CLOCKSPEED_2400