Expand Configuration and Management Manual (H06.21+, J06.10+)

Configuring Multi-Line Paths
Expand Configuration and Management Manual — 529522-013
13 - 21
PEXQMIP Modifiers
PEXQMIP Modifiers
The disk file $SYSTEM.SYSnn.PEXQMIP defines modifiers for Expand-over-IP lines in
multi-line paths. Table 13-6 lists the default value and range of values for each modifier
in this profile, if applicable. For modifiers that are mutually exclusive, a check mark (3)
is shown in the “Default Value” column to indicate which modifier is present in the
profile.
Table 13-6. PEXQMIP Modifiers (page 1 of 2)
Modifier Default Value Range of Values
AFTERMAXRETRIES_DOWN
AFTERMAXRETRIES_PASSIVE 3
ASSOCIATEDEV
1
None Any 8-character string
CONNECTTYPE_ACTIVEANDPASSIVE 3
CONNECTTYPE_PASSIVE
DESTIPADDR
2
0.0.0.1 Any 36-character string
DESTIPPORT
1
1024 0 through 65534
DOWNIFBADQUALITY_ON
DOWNIFBADQUALITY_OFF 3
EXTMEMSIZE 2048 0 through 32767
FRAMESIZE 132 64 through 2047
IPVER_IPV4 3
IPVER_IPV6
L2RETRIES 20 1 through 255
LINEPRIORITY 1 1 through 9
LINETF 0 0 through 186
MAXRECONNECTS 0 0 through 32767
QUALITYTHRESHOLD 0 0 to 99
QUALITYTIMER 60 seconds 0 to 77600 (12hrs)
RETRYPROBE 19 1 through 255
RXWINDOW 7 2 through 15
SPEED 0 0 or 1200 through
2240
00
SPEEDK NOT_SET 0 through 4,000,000,000
SRCIPADDR
2
0.0.0.1 Any 36-character string
SRCIPPORT
1
1024 0 through 65534
STARTUP_OFF 3
STARTUP_ON
TXWINDOW 7 2 through 25