Expand Configuration and Management Manual (H06.21+, J06.10+)

Configuring Multi-Line Paths
Expand Configuration and Management Manual — 529522-013
13 - 22
PEXQMATM Modifiers
PEXQMATM Modifiers
The disk file $SYSTEM.SYSnn.PEXQMATM defines modifiers for Expand-over-ATM
lines in multi-line paths. Table 13-7 lists the default value and range of values for each
modifier in this profile, if applicable. For modifiers that are mutually exclusive, a check
mark (3) is shown in the “Default Value” column to indicate which modifier is present in
the profile.
V6DESTIPADDR 0000:0000:0000:
0000:0000:0000:
0000:0000
Any 45-character string
V6SRCIPADDR 0000:0000:0000:
000
0:0000:0000:
0000:0000
Any 45-character string
1. This is a required modifier.
2. This is a required modifier. For IP address syntax, see the TCP/IP Configuration and Management Manual,
TCP/IP (Parallel Library) Configuration and Management Manual, or TCP/IPv6 Configuration and Management
Manual.
Table 13-7. PEXQMATM Modifiers (page 1 of 2)
Modifier Default Value Range of Values
AFTERMAXRETRIES_DOWN OFF ON or OFF
AFTERMAXRETRIES_PASSIVE 3 ON or OFF
ASSOCIATEDEV
1
None Any 8-character string
CONNECTTYPE_ACTIVEANDPASSIVE 3 ON or OFF
ATMSEL
2
%H80 0 through %HFF
CALLTYPE_PVC
3
3
CALLTYPE_SVC
2
CONNECTTYPE_PASSIVE
DESTATMADDR
2
(ISONSAP:
%H00...)
Any valid ISO NSAP ATM
address
DOWNIFBADQUALITY_ON
DOWNIFBADQUALITY_OFF 3
FRAMESIZE 132 64 through 2047
L2RETRIES 20 1 through 255
LINEPRIORITY 1 1 through 9
LINETF 0 0 through 186
MAXRECONNECTS 0 0 through 32767
PVCNAME
3
None Any 8-character string
Table 13-6. PEXQMIP Modifiers (page 2 of 2)
Modifier Default Value Range of Values