Expand Configuration and Management Manual (H06.21+, J06.10+)

Subsystem Control Facility (SCF) Commands
Expand Configuration and Management Manual — 529522-013
14 - 10
ALTER Command
ALTER Command
The ALTER command changes the values for PATH object types, LINE object types,
and the PROCESS $NCP object type. ALTER is a sensitive command.
The ALTER command syntax is:
ALTER DEVICE Command
The WAN subsystem ALTER DEVICE command changes the values of a data
communications subsystem object.
The ALTER DEVICE command changes only the specified attributes of the target
object. For more information on this command, see the WAN Subsystem Configuration
and Management Manual.
The ALTER DEVICE command has this syntax (you must specify one or more
attributes):
Considerations
The default value for HIGHPIN is "ON" because HP expects that no one would ever
want a line handler to run at low pin. However, if you want to change this value to
"OFF" you must do so explicitly by issuing this commands to SCF:
1-> abort line $lh01
2-> stop device $zzwan.#lh01
3-> alter device $zzwan.#lh01, highpin off
4-> start device $zzwan.#lh01
5-> start line $lh01
Note that in Step 1, you must stop the line to stop the device, and in Step 2, you must
stop the device to alter the device.
ALTER { PROCESS $NCP | PATH path-name | LINE line-name }
ALTER DEVICE $ZZWAN.#device-name
[ , ADAPTER conc-name ]
[ , CLIP clip-num ]
[ , HIGHPIN "ON" | "OFF" ]
[ , IOPOBJECT object-file-name ]
[ , LINE line-num ]
[ , modifier-keyword [ modifier-value ] ]...
[ , PATH path-name ]
[ , [ RECSIZE | RSIZE ] max-rex-size ]
[ , RESET
[ ( modifier-keyword [ modifier-keyword ... ] ) ] ]
[ , TYPE ( type , sub-type ) ]