Expand Configuration and Management Manual (H06.21+, J06.10+)

Subsystem Control Facility (SCF) Commands
Expand Configuration and Management Manual — 529522-013
14 - 12
Considerations
Considerations
•
You can alter several paths with a single ALTER command by specifying multiple
PATH objects using parentheses as:
-> PATH ( path-name , path-name [ , path-name ] ... )
Examples
This SCF command changes the value of the path’s NEXTSYS attribute to system 100
and the value of its TIMERINACTIVITY attribute to 9 minutes and 30 seconds:
-> ALTER PATH $PATH1, NEXTSYS 100, TIMERINACTIVITY 9:30.00
This SCF command changes the value of the TIMERINACTIVITY attribute to 10
minutes for two different paths:
-> ALTER PATH ($PATH2,$PATH3), TIMERINACTIVITY 10:00.00
ALTER LINE Command
The ALTER LINE command is described below. The LINE object type takes this form:
LINE line-name attribute-spec [, attribute-spec ]...
where line-name is the device name of a line and attribute-spec is one of
this attribute name and value combinations: