Expand Configuration and Management Manual (H06.21+, J06.10+)

Subsystem Control Facility (SCF) Commands
Expand Configuration and Management Manual — 529522-013
14 - 21
ALTER PROCESS Command
ALTER PROCESS Command
The ALTER PROCESS command changes the values of the attributes of the network
control process ($NCP). This command changes only the specified attributes of $NCP.
ALTER PROCESS is a sensitive command.
The ALTER PROCESS command for $NCP has this syntax:
where attribute-spec for the PROCESS object type for $NCP has this attribute
name and value combination:
Table 14-6 lists the $NCP attributes that have corresponding profile modifiers.
For more information on the $NCP attributes that have corresponding profile modifiers,
see the description of the corresponding profile modifier in Section
6, Configuring the
Network Control Process.
These $NCP attributes do not have corresponding profile modifiers:
ALTER PROCESS $NCP attribute-spec [ attribute-spec ] ...
[ ABORTTIMER time ]
[ AUTOREBAL { ON | OFF } ]
[ AUTOREBALTIME { time | ( time, start-time ) } ]
[ CONNECTTIME time ]
[ MAXCONNECTS integer ]
[ MAXTIMEOUTS integer ]
[ NETWORKDIAMETER integer ]
[ REBALTHRESHOLD integer ]
[ MSG43 { ON | OFF } ]
[ MSG46 { ON | OFF } ]
[ MSG48 { ON | OFF } ]
[ MSG49 { ON | OFF } ]
Table 14-6. ALTER PROCESS Attributes and Corresponding Profile Modifiers
SCF Attribute Profile Modifier
ABORTTIMER
ABORTTIMER n
CONNECTTIME CONNECTTIME n
MAXCONNECTS MAXCONNECTS n
MAXTIMEOUTS MAXTIMEOUTS n
NETWORKDIAMETER NETWORKDIAMETER n
REBALTHRESHOLD REBALTHRESHOLD n