Expand Configuration and Management Manual (H06.21+, J06.10+)

Subsystem Control Facility (SCF) Commands
Expand Configuration and Management Manual — 529522-013
14 - 38
Expand-Over-IP Line-Handler Processes
L2Protocol
is the Layer 2 protocol process associated with the Expand-over-IP line-handler
process.
TimeFactor
reports the current time factor for this line. For a discussion on time factors,
including how to calculate them, see Routing and Time Factors on page 17-22.
SpeedK
calculates the time factor of the line for the Expand routing algorithm. A value of
NOT_SET means that this parameter was not set. For a discussion of SPEEDK,
see SPEEDK n on page 16-23.
Framesize
specifies the maximum size frame that can be sent in the network; smaller frames
can be sent. The Exp
and subsystem also uses the FRAMESIZE modifier to
calculate the packet size and determine the size of the frame buffers. If the default
FRAMESIZE modifier value is used, the packet size is 132 words.
Rsize
specifies the time factor of the line for the Exp
and routing algorithm. RSIZE can be
0 if the time factor is set using some other modifier.
Speed
calculates the time factor of the line for the Expand routing algorithm.
Example 14-8. INFO LINE, DETAIL Command, Expand-Over-IP Line-Handler
Processes for IPv6 Lines
-> INFO LINE $IPTAH0, DETAIL
EXPAND Detailed Info LINE $IPTAH0 (LDEV 175)
L2Protocol Net^Ip TimeFactor...... 3 *SpeedK........ NOT_SET
Framesize....... 132 -Rsize........... 3 -Speed........
*LinePriority.... 1 StartUp......... OFF *Delay......... 0:00:00.10
*DownIfBadQuality OFF *QualityThreshold 96 *QualityTimer.. 0:01:00.00
*Txwindow........ 7 *Maxreconnects... 0 *AfterMaxRetries PASSIVE
*Timerreconnect 0:00:30.00 *Retryprobe...... 19 *Timerprobe.... 0:00:01.00
*Associatedev.... $ZTC02 *LineTf.......... 0 *Timerinactivity 0:00:00.00
*IPVer IPV6
*DestIpAddr 16.107.190.66 *DestIpPort......11171
*SrcIpAddr 16.107.188.67 *SrcIpPort.......11171
*V6DestIpAddr fe80::a00:8eff:fe00:897b
*V6SrcIpAddr fe80::a00:8eff:fe00:897a