Expand Configuration and Management Manual (H06.21+, J06.10+)

Subsystem Control Facility (SCF) Commands
Expand Configuration and Management Manual — 529522-013
14 - 47
Expand-Over-NAM and Expand-Over-ServerNet
Line-Handler Processes
it is the subdevice name of a SNAX/APN logical unit (LU). This field is not used by
Expand-over-ServerNet line-handler processes.
Example 14-13 shows the display format for a LINE object with the DETAIL option for
Expand-over-NAM or Expand-over-ServerNet line-handler processes. The asterisk (*)
indicates an alterable attribute.
L2Protocol
lists the name of the Layer 2 protocol process associated with the Expand-over-
NAM or Expand-over-ServerNet line-handler process.
TimeFactor
reports the current time factor for this line. For a discussion about time factors,
including how to calculate them, see Routing and Time Factors on page 17-22.
SpeedK
calculates the time factor of the line for the Expand routing algorithm. A value of
NOT_SET means that this parameter was not set. For a discussion of SPEEDK,
see SPEEDK n on page 16-23.
Framesize
specifies the maximum size frame that can be sent in the network; smaller frames
can be sent. The Exp
and subsystem also uses the FRAMESIZE modifier value to
calculate the packet size. The FRAMESIZE modifier value also determines the size
of the frame buffers.
Rsize
displays the time factor of the line for the Exp
and routing algorithm. RSIZE can be
0 if the time factor is set using some other modifier.
Speed
calculates the time factor of the line for the Expand routing algorithm.
Example 14-13. INFO LINE, DETAIL Command, Expand-Over-NAM and
Expand-Over-ServerNet Line-Handler Processes
-> INFO LINE $SC151, DETAIL
L2Protocol Net^Nam TimeFactor...... 1 *SpeedK........ NOT_SET
Framesize....... 132 -Rsize........... 1 -Speed........
*LinePriority.... 1 StartUp......... OFF Delay......... 0:00:00.10
*Rxwindow........ 7 *Timerbind... 0:01:00.00 *L2Timeout..... 0:00:01.00
*Txwindow........ 7 *Maxreconnects... 0 *AfterMaxRetries PASSIVE
*Timerreconnect 0:01:00.00 *Retryprobe...... 10 *Timerprobe.... 0:00:30.00
*Associatedev.... $ZZSCL *Associatesubdev *Timerinactivity 0:00:00.00
*ConnectType..... ACTIVEANDPASSIVE
*LineTf.......... 0