Expand Configuration and Management Manual (H06.21+, J06.10+)

Subsystem Control Facility (SCF) Commands
Expand Configuration and Management Manual — 529522-013
14 - 48
Expand-Over-NAM and Expand-Over-ServerNet
Line-Handler Processes
LinePriority
can be set in the range 1 to 9. The default is 1. The higher the number, the lower
priority to use that line. If lines have equal priority, the relative line speeds and
transmission delays are used to select the next line.
StartUp
shows that the line will be disabled (OFF) or enabled (ON) after a system load.
Delay
reports the time interval between transmissions. For a description of the time
interval format, see Time Values on page 14-6.
Rxwindow
specifies the number of packets that the input-output process (IOP) will send to the
line-handler process before the line-handler process must send a reply.
Timerbind
specifies the time interval that the Expand-over-NAM or Expand-over-ServerNet
line-handler process will wait for a completion of its bind request to the NAM
process. For a description of the time interval format, see Time Values on
page 14-6.
L2Timeout
specifies the time interval that the line-handler process will wait for a response to
request at Layer 2 before retrying. For a description of the time interval format, see
Time Values on page 14-6.
Txwindow
reports the number of Expand packets that the line-handler process can send
before receiving a reply.
Maxreconnects
is the maximum number of times the Expand-over-NAM or Expand-over-ServerNet
line-handler process will try a connect request after successfully binding to the
NAM interface.
AfterMaxRetries
lists the line state after all retries have been exhausted for the Expand-over-NAM
or Expand-over-ServerNet line-handler process. DOWN causes the line state to be
down. PASSIVE causes the Expand-over-NAM process to switch to
PASSIVECONNECTONLY (which supersedes the function of
ACTIVEANDPASSIVECONNECT). This attribute applies to Expand-over-NAM and