Expand Configuration and Management Manual (H06.21+, J06.10+)

Subsystem Control Facility (SCF) Commands
Expand Configuration and Management Manual — 529522-013
14 - 51
INFO PROCESS Command
LINESET
displays the status of a selected path and the status of the started lines that make
up that path.
NETMAP
displays the status of the network as seen from a specific system.
PATHSET
displays the NCP pathmap information, similar to the LINESET option but in a
different format. This new format displays both the line-handler LDEV and name in
addition to the other information already in the LINESET option.
SUPERPATH
displays the paths comprising each multi-CPU path on the system.
RPT system-name
displays the reverse pairing table (RPT) for the specified multi-CPU path.
SYSTEMS
displays all known systems. If no connection is established, the SYSTEMS option
displays an infinite time factor and hop count. The SYSTEMS option is similar to
the CONNECTS option, except that the CONNECTS option displays only the
systems connected.
AT { system-list | * }
where
system-list
is ( [ sys-a [ , sys-b [ , sys-c [ , .... ] ] ] ] ).
sys-a
is {\system-name | system-number }.
sys-b
is {\system-name | system-number }.
Note. The LINESET option only displays information on active lines (lines that have been
started at least after a system load). To see information on all configured lines, use the SCF
command LISTDEV TYPE 63.
Note. If none of the formatting options (LINESET, NETMAP, PATHSET, SUPERPATH, and
RP
T) are specified, local $NCP information is displayed.