Expand Configuration and Management Manual (H06.21+, J06.10+)

Subsystem Control Facility (SCF) Commands
Expand Configuration and Management Manual — 529522-013
14 - 52
INFO PROCESS Command
sys-c
is {\system-name | system-number }.
If the NETMAP, SUPERPATH, or RPT option is chosen, only one system can be
specified.
If the SUPERPATH option is chosen, the display lists the multi-CPU paths on a
remote node.
If the RPT option is chosen, the display lists the reverse pairing table (RPT) on a
remote node.
If the AT option is omitted, the SCF target system is assumed.
If AT * is specified and the LINESET or PATHSET option is chosen, the display is
the status of a selected path and the lines that make up the path of all accessible
nodes in the network.
TO { system-list | * }
where
system-list
is ( [ sys-a [ , sys-b [ , sys-c [ , .... ]]]] ).
sys-a
is {\system-name | system-number }.
sys-b
is {\system-name | system-number }.
sys-c
is {\system-name | system-number }.
The TO option is valid only when NETMAP has been selected. It causes the
display of the network st
atus as viewed from the system specified in the AT option
through the system specified in the TO option.
If the TO option is omitted and the NETMAP option is selected, the status of the
whole network as seen from the system specified in the AT option is displayed. If
this option is specified as TO * and the NETMAP option is selected, the status of
the whole network as seen from the system specified in the AT option is displayed.
DETAIL
causes detailed information of $NCP attributes to be displayed. If not specified,
only one line of $NCP attribute information is displayed.