Expand Configuration and Management Manual (H06.21+, J06.10+)

Subsystem Control Facility (SCF) Commands
Expand Configuration and Management Manual — 529522-013
14 - 55
INFO PROCESS Command
Framesize
is used by $NCP to compute the maximum size, in words, of a distance vector
(DV) packet.
Maxtimeouts
defines the maximum number of retry attempts allowed to establish a connection.
Maxconnects
specifies the maximum number of times $NCP will attempt a connection (CONN)
request.
NetworkDiameter
specifies the maximum number of intervening systems (hops) in a path between
two systems.
Type
reports the device type (device-type,subtype). $NCP is 62,0.
Message 43
reports whether the reporting of event message 43 to $0 is enabled (ON) or
disabled (OFF). Message 43 is a critical message. It means that the connection to
the indicated system has been lost.
Message 44
reports whether the reporti
ng of event message 44 to $0 is enabled (ON).
Message 44 is not critical. It means that the indicated line is now ready to accept
network requests.
Message 45
reports whether the reporti
ng of event message 45 to $0 is enabled (ON).
Message 45 is a critical message. It means that the indicated line is no longer
ready.
Message 46
reports whether the reporting of event message 46 to $0 is enabled (ON) or
disabled (OFF). Message 46 is not critical. It means a connection has been made
with the indicated remote system.
Note. The network control process FRAMESIZE modifier and the Layer 2 SCF FRAMESIZE
modifier have the same name. Both the network control process and the Layer 2 FRAMESIZE
modifiers are configured using the SCF interface to the WAN subsystem. Expand modifiers are
described in Section
16, Expand Modifiers