Expand Configuration and Management Manual (H06.21+, J06.10+)

Subsystem Control Facility (SCF) Commands
Expand Configuration and Management Manual — 529522-013
14 - 66
RPT Option
Line
indicates the line number.
Name
indicates the device name of the line.
Ldev
indicates the logical device (LDEV) number associated with each line logical
device.
Status
indicates the status of the line; whether it is ready or not ready.
FileErr
shows the most recent file system error number, if any, associated with each line.
For recovery information on file errors, see Identifying Network Problems on
page 20-3.
RPT Option
The display for the INFO PROCESS $NCP command with the RPT option has the
format as shown in Example 14-21:
AT \nnn (xxx)
is the name (nnn) and number (xxx) of the system at which the reverse p
airing
table (RPT) is viewed.
SPATH n
these entries describe information kept in the RPT for each multi-CPU path
(SPATH) on the selected system. When data is transmitted to a non-neighbor node
over a multi-CPU path, the RPT is used to direct traffic from the remote node to the
Expand line-handler process from which a connection initiation was received. The
source system numbers and the logical devices (LDEVs) to which traffic from the
source system should be directed are shown in the SYS/LDEV columns. Only
Example 14-21. INFO PROCESS $NCP Command, RPT Option
-> INFO PROCESS $NCP, RPT \NODEA
EXPAND Info PROCESS $NCP , RPT
SUPERPATHS AT \NODEB (85) #SUPERPATHS=1 TIME: APR 26,2000 13:55:01
S-PATH NEIGHBOR SYS/LDEV SYS/LDEV SYS/LDEV SYS/LDEV
1 \NODEA (102) 80 234 190 245