Expand Configuration and Management Manual (H06.21+, J06.10+)

Subsystem Control Facility (SCF) Commands
Expand Configuration and Management Manual — 529522-013
14 - 67
SUPERPATH Option
entries with valid LDEVs are displayed. For more information on the RPT, see
Network Routing Table (NRT) and Multiple Path Table (MPT) on page 17-25.
NEIGHBOR
indicates the neighbor node that data is transmitted to over the path.
SYS/LDEV
indicates the number and the name of the system, or node, and the logical device
(LDEV) number.
SUPERPATH Option
The display for the INFO PROCESS $NCP command with the SUPERPATH option
has the format as shown in Example 14-22:
AT \nnn (xxx)
is the name (nnn) and number (xxx) of the system from which the multi-CPU
paths are viewed.
SPATH n
these entries describe each multi-CPU path (SPATH) on the selected system. The
ef
fective time factor (ETF) is an extension of the path time factor (TF) that is used
to select a path in a multi-CPU path. The ETF represents not only the speed of the
path, but also the resources available on the path to accommodate more traffic.
The LCPU and RCPU fields report the local processor and remote processor
numbers. For more information on the ETF, see Best-Path Route Selection on
page 17-24.
NEIGHBOR
indicates the neighbor node that data is transmitted to over the path.
LDEV
indicates the logical device (LDEV) number associated with each line logical
device.
Example 14-22. INFO PROCESS $NCP Command, SUPERPATH Option
-> INFO PROCESS $NCP, SUPERPATH
EXPAND Info PROCESS $NCP , SUPERPATH
SUPERPATHS AT \NODEA (117) #SUPERPATHS=1 TIME: FEB 24,2003 13:55:48
S-PATH NEIGHBOR LDEV TF LF LCPU RCPU
1 \NODEB (082) 122 1 1.00 1 1
121 1 1.00 0 2
123 1 1.00 0 0