Expand Configuration and Management Manual (H06.21+, J06.10+)

Subsystem Control Facility (SCF) Commands
Expand Configuration and Management Manual — 529522-013
14 - 107
STATUS LINE Command
BINDING
indicates that the Expand-over-IP or line-handler process is binding to the local
NonStop TCP/IP process, that the Expand-over-ATM line-handler process is
binding to the configured permanent virtual circuit (PVC) name, or that the
Expand-over-NAM line-handler process is binding to the local network access
method (NAM) process.
CALLING
indicates that the Expand-over-ATM line-handler process is attempting to
establish a switched virtual circuit (SVC) connection to the remote system. This
state applies to Expand-over-ATM line-handler processes that use SVC
connections only.
CONNECTED
indicates that a connection has been established.
CONNECTING
indicates that the Expand line-handler process is attempting to connect to the
remote (destination) Expand line-handler process.
DISCONNECTING
indicates that the inactivity timer expired for the Expand line-handler process; it
sent a disconnect message, and is waiting for a reply.
DOWN
indicates that the Layer 2 functions of the Expand line-handler process are
down.
DOWN SOCKET
an internal state that should not persist. This st
ate applies to Expand-over-IP
line-handler processes only.
DOWN WAIT
an internal state that should not persist. This state applies to Expand-over-IP
line-handler processes only.
INACTIVE
indicates that the Expand line-handler process is inactive. It is either waiting for
dat
a to send or is waiting for an active connect from the other side.
LISTEN
indicates that the Expand-over-ATM line-hand
ler process is waiting for
switched virtual circuit (SVC) connection establishment from the remote