Expand Configuration and Management Manual (H06.21+, J06.10+)

Subsystem Control Facility (SCF) Commands
Expand Configuration and Management Manual — 529522-013
14 - 108
STATUS LINE Command
system. This state applies to Expand-over-ATM line-handler processes that
use SVC connections only.
PASSIVE
indicates that the Expand line-handler process is waiting for the remote
(destination) Expand line-handler process to initiate a connection.
QUERY
indicates that the Expand line-handler process is connected to the remote
(destination) Expand line-handler process, but no data has been received
within the inactivity interval (SCF TIMERPROBE attribute). The Expand line-
handler process is sending Probe messages to the remote Expand line-handler
process to verify that it is operational.
RECONNECTING
indicates that the Expand line-handler process received data while it was
inactive, sent an active connect, and is waiting for a reply.
REPASSIVE
indicates that the Expand line-handler process received data while it was
inactive, sent an passive connect, and is waiting for a reply.
SETOPT_CALLING
an internal state that should not persist. This state applies to Expand-over-ATM
line-handler processes only.
SETOPT_LISTEN
an internal state that should not persist. This state applies to Expand-over-ATM
line-handler processes only.
SOCKET_REUSE
an internal state that should not persist. This st
ate applies to Expand-over-IP
line-handler processes only.
SOCKET SETUP
an internal state that should not persist. This st
ate applies to Expand-over-IP
line-handler processes only.
SOCKET_SPACE
an internal state that should not persist. This st
ate applies to Expand-over-IP
line-handler processes only.